- motorola Installation and Operation Manual Portable Radio GP68

Model ST-865M3 SmarTrunk II
™ Logic Board
36
The sequence for programming the five digit access
code requires the dealer to enter the five digit number
two times. This insures that no mistakes are made dur-
ing the entry of a new access code.
To change the five digit access code: Enter the program
code 16 followed by the # key, then the new five digit
access code followed by the # key. Then enter the five
digit access code a second time, followed by the # key.
If the new access code was entered the same both times,
the programming of the new access code will be ac-
cepted.
To change the five digit access code to 45678 press:
1 6 # 4 5 6 7 8 # 4 5 6 7 8 #
4.2.6 Return To Radio Default Values
This programming feature will return the contents of
the EEPROM to the default values as shown on the
Programming Options Summary Table (Table 4-1). The
Five Digit Access code is returned to the factory de-
fault value (12345).
Example: To initialize the EEPROM TO FACTORY
DEFAULTS PRESS: 1 9 #.
4.2.7 Trunking System ID Number
All ST-852’s have a Trunking System ID Number from 0
to 31. All subscriber units on a trunking system must
be programmed with the same trunking system ID num-
ber. Subscriber units can only access ST-852’s with
matching Trunking System ID Numbers.
For example, if a subscriber unit with a trunking system
ID number of 1 tries to access a trunking system with a
trunking system ID number of 5, access will be denied.
If you wish to allow subscriber units to roam on differ-
ent SmarTrunk II systems, all trunking system ID num-
bers must be identical. The Trunking System ID Num-
ber will be used in the future for roaming and network-
ing features.