Installation guide

C M Y CM MY CY CMY K
Mini USB
Connection
(M900 only)
Octopus control
cable
Data cable
Data connection/maintenance cable
The Data connection wire in M800 and the mini USB connection in M900 enable
using the fixed mobile car phone as a modem or to synchronize data with external
computers using Motorola MPT program.
The data connections also enable authorized technicians to maintain the fixed
mobile car phone for technical service purposes (Software programming).
Aux Alert
+12V GND MUTE IGN
2A Fuse
VAD key
Soft keys
Navigation key
Volume keys
Special functions
Voice Activation Dialing key (VAD)
The VAD is the blue illuminated key on the top side of the main control unit. This
special button, designed as a mouse key is a multiple operations button which
enables the user to voice activate Name & Number dialing, notice incoming calls,
record voice memos and end or receive phone calls by clicking on the button once.
Volume keys
The volume keys, located on the left hand side of the main control unit enable the
users to adjust audio volume during a call and to adjust the ringer volume during
stand by. While installing the phone in the vehicle don’t place the main control unit
close to the car dashboard or to any other component that might interrupt with the
volume keys operation.
Soft keys and shortcuts
The two soft keys located on the lower part of the phone display enable users to
customize their phone and set useful menus for their convenience and intuitive
location on their phone display.
The navigation key enables the users to launch pre-defined menus (phone book,
browser, volume level setup) in a very quick and intuitive way instead of entering
the phone menus. The navigation key setup may vary from model to model.
Mount the privacy handset using the plastic base and connect the handset jack to
the socket at the bottom of the main control unit.
Attach the privacy handset cable to the head control unit’s holder using plastic strip.
Handset
base
Handset
base mount
Unit Holder
Plastic Strip
Verify that
the cable
is not tight
Privacy Handset/Headset
RED
Wire color Function Connect to... Ensure...
To supply steady
(+) power source.
12V steady
power.
An additional fuse
is supplied that
must be
connected to the
positive (+) pole.
The use of a 2A/250V
fuse.
BLACK To supply steady
(-) power source.
Vehicle body That the contact point
is only connected to
the vehicle body.
GREEN To switch the
phone on when
the car ignition is
turned on, and off
when the car
ignition is turned
off.
IGN voltage The appropriate
voltage using
voltmeter. Ensure the
use of a 2A/250V
fuse.
ORANGE To mute the car
stereo system
when receiving or
dialing a call.
Car stereo
system
Entertainment
Mute connection
(optional)
That the connection
between the Fixed
Mobile Car Phone
and car stereo system
should be done by an
authorized installer
only. sink shoud be up
to 150mA.
WHITE To operate car
lights/horn to
indicate incoming
call.
Car lights/horn
connections
(optional)
That the connection
between the Fixed
Mobile Car Phone
and the car lights/horn
should be done by an
authorized installer
only. sink shoud be up
to 300mA.
Connections summary
Cable connections
Power
Connect the RED wire to a positive (+) 12V pole for steady power supply. Ensure
the use of a 2A/250V fuse.
Ground
Connect the BLACK wire to a negative pole (-) in the vehicle body. Ensure the use
of a 2A/250V fuse.
Ignition
Connect the GREEN wire to car IGN voltage and check the appropriate voltage
using voltmeter. This connection switches the phone on when turning the ignition
on and it switches the phone off when turning the ignition off. Ensure the use of a
2A/250V fuse.
Entertainment Mute
Connect the ORANGE wire to the car stereo system entertainment mute connection
to mute the stereo system when receiving or dialing a call.
Auxiliary alert
Connect the WHITE wire to the car’s horn and/or to the car’s light connection to
turn on the lights and/or to activate the horn when receiving a call.
*Aux. Alert is an optional feature.
1211
Motorola Proprietary Motorola Proprietary Motorola Proprietary
10
Motorola Proprietary
8
Motorola Proprietary
9
Motorola Proprietary
7
Heavy vehicles with 24v
When installing the Fixed Mobile Car Phone in trucks or in any other heavy vehicle
with 24 volt battery, connect the RED wire via 24VDC to 12VDC (50W) voltage
converter.
The Ignition line (GREEN) in M900 can be connected directly to the truck ignition
switch (24V) and in M800 MUST be connected to 12V only.
*Ent. Mute is an optional feature.
*Certain M800 models have a 3-wires connection, without Auxiliary alert and entertainment mute wires.
Cable connections (continue)
Ent. Mute & Aux. Alert Open Collector connection
12V
M800/M900
Command signal
Relay
Common
Normally
Open
Normally
Close
Connect to white wire (for
Aux. Alert) or to orange
wire (for Ent. Mute)