Two User Manual

Programming Mode
24
Programming the Interference Eliminator Code
The interference eliminator code helps minimize interference by providing code combinations
that filter out static, noise, and unwanted messages.
1. In programming mode, press
S until y displays and the code
number flashes.
2. Press
[
or
]
to select the c ode (see page 37).
3. Press and hold
Push to Talk to exit programming mode, or press
S
to
continue programming.
Programming the Available Channels
If you need fewer channels, you can reduce the number of available channels.
1. In programming mode, press
S until = displays and the channel number
flashes.
2. Press
[
or
]
to select the number of channels you want available.
3. Press and hold
Push to Talk to exit programming mode, or press
S
to
continue programming.
Note: The radio retains settings for channels made unavailable.
Programming Call Tones and VibraCall
®
Your radio can transmit call tones to other radios in your group so you can alert them that you
are about to talk. Your radio is programmed at the factory with call tones turned off (set to
0 ),
but you can change this setting to
choose a distinctive call tone.
VL50operation.fm Page 24 Tuesday, February 24, 2004 4:46 PM