Two User Manual

Cloning Radio Settings

You can copy VL50 radio settings from one radio (the source) to a second radio using the

56531 Multi-Unit Charger (MUC) optional accessory. See the MUC User's Guide for more

information.

You can clone only one radio at a time. A multi-channel radio can clone to a single-channel

radio, but only the first channel is cloned. The MUC does not have to be plugged in for cloning,

but both radios require charged batteries.

1. On the source radio, press and hold

Push to Talk

and

for 3 seconds while turning the

radio on. The radio beeps and displays

2. Place the source radio in one of the charging pockets.

3. Turn the target radio on and place it in the charging pocket that is

paired with the pocket containing the source radio. There are

3 paired charging pockets as indicated by the 3 pairs of charging

status LEDs.

4. Press and hold

on the source radio. The source radio transmits its

settings to the target radio. If cloning was successful, P or Pass

displays on the source radio and the target radio displays all feature

icons. If cloning was not successful, F or Fail displays on the source

radio.

5. Turn the target radio off and back on again to use.

6. To clone another radio, repeat steps 3 and 4.

7. To exit programming mode on the source radio, press and hold

Push to Talk

until

no longer appears.

031102o

LEDs

Paired

pockets

VL50operation.fm Page 27 Thursday, February 26, 2004 2:51 PM