Technical data

http://www.mcg.mot.com/literature IN-3
I
N
D
E
X
H
handshaking 2-7
hardware
features 4-1
initialization 2-3
interrupts 4-14
preparation 1-1
high-temperature operation A-3
humidity, relative A-1
I
I/O interfaces 4-10
IACK (interrupt acknowledge) signal 1-19
indicators 2-1
IndustryPack (IP) interfaces 4-11
IndustryPack modules
base addresses of 3-19
configuration 3-21
configuring 3-19
general control register 3-20
installation 1-17
memory size 3-20
IndustryPack signals 5-2
initial conditions 2-4
installation considerations 1-20
installation instructions 1-17
interconnect signals 5-1
interrupt acknowledge signal (IACK) 1-19
interrupt control registers 3-21
Interrupt Stack Pointer (ISP) 3-4
interrupts 4-14
IOT command parameters for supported
floppy types D-3
IP bus clock header (J11) 1-7
IP bus strobe signal 1-10
IP installation 1-17
IP32 CSR bit 1-8
ISP (Interrupt Stack Pointer) 3-4
J
jumper headers
J1 (system controller selection) 1-7
J11 (IP bus clock) 1-7
J12 (SCSI termination) 1-8
J14 (SRAM backup power) 1-9
J18 (IP bus strobe) 1-10
J19 (IP DMA snoop control) 1-11
J20 (EPROM/Flash configuration) 1-11
J21 (software-readable headers) 2-5
J23 (Flash write protection) 1-10
jumper headers, location of 1-4
jumpers, backplane 1-19
L
LAN interface 4-12
LEDs (light-emitting diodes) 2-1
local
bus 4-14
bus arbiter 4-15
bus timeout 4-14
resources for the processor 4-13
location monitors, processor 1-20
M
MC2chip ASIC 1-13
MC2chip registers 1-14
MC68060 or MC68LC060 MPU 4-5
MC68xx060 cache memory 4-5
memory boards 1-16
memory mezzanine stacking options 1-16
memory options 4-6
memory requirements 3-3
mezzanine boards 1-16
mezzanine signals 5-5, 5-7
microprocessor 4-5
MPU 4-5
MVME172
as network controller C-1
board specifications A-1
cooling requirements A-2
EMC regulatory compliance A-4