Technical data

Hardware Installation
2-3
2
Figure 2-1. PMC Module Placement on PMCspan
3. Slide the PMC module port connector into the PMC slot opening on
the PMCspan front panel
4. Align the PMC adapter over the PMCspan.
– Align the connectors on the underside of the PMC adapter with
the corresponding connectors (J11, J12, and J14) on the
PMCspan.
– Align the keying hole on the PMC adapter with the keying pin
on the PMcspan.
5. Gently press the PMC adapter onto the PMCspan.
6. Turn the PMCspan component-side down.
7. Insert the four short Phillips screws supplied with the PMC adapter
through the holes on the underside of the PMCspan, into the
standoffs at the corners of the PMC adapter (note that some PMC
adapters take a screw at each corner; others require only two screws
at the forward corners). Tighten the screws.
2021 9704