Technical data

Hardware Installation

2-11

5. Remove the four short Phillips screws from the standoffs in each

corner of the Primary PMC Carrier Module.

6. Attach the four standoffs to the Primary PMC Carrier Module.

7. Place the Secondary PMCspan module on top of the Primary

PMCspan module. Align the mounting holes in each corner to the

standoffs, and align secondary PMCspan connector P3 with primary

PMCspan connector J3.

8. Gently press the two PMCspan modules together, making sure that

P3 is fully seated in J3.

9. Insert the four short Phillips screws through the holes at the corners

of the secondary PMCspan and into the standoffs on the primary

PMCspan. Tighten the screws.

Note The screws have two different head diameters. Use the

screws with the smaller heads on the standoffs next to

VMEbus connectors P1 and P2.

10. Install the VME processor module/PMCspan assembly into the card

slots. Be sure the modules are well seated in the backplane

connectors. Do not damage or bend connector pins.

11. Replace the chassis or system cover(s), reconnect the system to the

AC or DC power source, and turn the equipment power on.