Technical data

All Motorola printed wiring boards (PWBs) are manufactured by UL-recognized
manufacturers, with a flammability rating of 94V-0.
!
WARNING
This equipment generates, uses, and can radiate electro-magnetic energy.
It may cause or be susceptible to electro-magnetic interference (EMI) if
not installed and used in a cabinet with adequate EMI protection.
If any modifications are made to the product, the modifier assumes
responsibility for radio frequency interference issues. Changes or
modifications not expressly approved by Motorola Computer Group could
void the user’s authority to operate the equipment.
The computer programs stored in the Read Only Memory of this device contain material
copyrighted by Motorola Inc. and may be used only under a license such as those contained
in Motorola’s software licenses.
The software described herein and the documentation appearing herein are furnished under
a license agreement and may be used and/or disclosed only in accordance with the terms of
the agreement.
The software and documentation are copyrighted materials. Making unauthorized copies is
prohibited by law.
No part of the software or documentation may be reproduced, transmitted, transcribed,
stored in a retrieval system, or translated into any language or computer language, in any
form or by any means without the prior written permission of Motorola, Inc.
European Notice: Board products with the CE marking comply with the EMC
Directive (89/336/EEC). Compliance with this directive implies conformity to
the following European Norms:
EN55022 (CISPR 22) Radio Frequency Interference
EN50082-1 (IEC801-2, IEC801-3, IEC801-4) Electromagnetic Immunity
The product also fulfills EN60950 (product safety) which is essentially the requirement
for the Low Voltage Directive (73/23/EEC).
This board product was tested in a representative system to show compliance with the
above mentioned requirements. A proper installation in a CE-marked system will maintain
the required EMC/safety performance.
For minimum RF emissions, it is essential that you implement the following conditions:
1. Install shielded cables on all external I/O ports.
2. Connect conductive chassis rails to earth ground to provide a path for connecting
shields to earth ground.
3. Tighten all front panel screws.