User Guide

X
Home Print Exit
Introduction Before You Begin Installation Configuration Troubleshooting Legal
10
USB
Ethernet
OUT
To Et h ernet
or USB
To ca bl e
outlet
To electrical
outlet
Cabling and Startup for a Single User
You must allow 5 to 30 minutes to power up the first time because the SB4101 must find
and lock on the appropriate channels for communications.
1 Be sure that your computer is on and the SB4101 is unplugged.
2 Connect the coaxial TV cable to the cable outlet or splitter and the other end to the
SB4101 connector marked CABLE. Hand-tighten the connectors to avoid damaging
them. You may need a 5-900 MHz splitter and an additional 75-ohm coaxial cable if
you have a TV connected to the cable outlet.
3 Insert the SB4101 CD-ROM into your CD-ROM drive.
4 Plug the power cord into the SB4101 connector marked POWER and the other end
to the electrical outlet.
Caution
Do not connect both Ethernet and USB cables to the same
computer.