Installation guide

SBV6220 Quick Start Guide 3

Installing the Battery

Place the SBV6220 on its side and press down on the two 1.

locking tabs to remove the battery cover from the bottom of

the digital voice modem.

Slide the battery into the battery compartment until it is fully 2.

seated.

Replace the battery cover with the locking tabs facing 3.

upward, and then push the cover into place.

Note: The battery may take up to 12 hours to reach a full

charge.

Please make sure to follow the installation instructions in the order presented. Before starting the installation, you must ﬁ rst install the

battery in your digital voice modem.

Connecting Your Digital Voice Modem

Cabling

Note: To prevent damage to the SBV6220 Digital Voice Modem

from static electricity, perform each installation step in the

following order:

1. Connect one end of the coaxial cable to a grounded cable

TV outlet or splitter.

2. Connect the other end of the coaxial cable to the Cable

connector on the rear of the SBV6220.

3. Insert the power cord plug into an AC electrical outlet.

4. Connect the power cord to the power adapter and insert

the power connector end of the power adapter into the

Power connector on the rear of the SBV6220.

IMPORTANT

Before starting this part of the installation, make sure to power off your computer and unplug the power cord to your •

digital voice modem.

Contact your cable service provider before connecting the Motorola SURFboard Digital Voice Modem to your existing •

telephone wiring. Do not connect the telephone cable from the TEL port to a traditional telephone service.