User`s guide

Section Six - S Register Summary

Your modem has 16 registers, designated S0 through S89. Table 6-1 shows

the registers, their functions, and their default values. Some registers can have

their values changed by commands. If you use a command to change a register

value, the command remains in effect until you turn off or reset your modem.

Your modem then reverts to the operating characteristics specified in its

nonvolatile memory. Refer to Section Five for information on how to use the

AT commands to manipulate the S registers.

NOTE:

The default value and range of some S-registers

listed below could vary with country.

Table 6-1 S - Registers

S0 Auto-answer or Ring Number 0-255 /rings 0

S1 Ring count 0-255 /rings 0

S2 Select Escape character 0-255 /ASCII 43

S3 SelectCarriage-return character 0-127 /ASCII 13

S4 Select Line-feed character 0-127 /ASCII 10

S5 Select Backspace character 0-127 /ASCII 8

S6 Blind Dial 0-255 /seconds 2

S7 Call Time-out 0-255 /seconds 60

S8 Pause Delay 0-255 /seconds 2

S10 DCD Loss Disconnect 0-255/0.1 second 14

S11 Tone Length 60-255 /milliseconds 72

S12 Escape Code Guard time 0-255 /0.02 second 50

S18 Test Timer 0-255 /second 0

NOTE:

Read bits from right to left..

Bit Signal Bit Signal