User`s guide

0 Caller ID (effective only where 2 Distinctive Ring (effective only

function is supported) where function is supported)

3 RING 4 DTMF Detection

5 Receive Buffer Overrun 6 Fax Calling

9 Presumed Hang-Up (SILENCE) 10 Presumed End-of-Message (QUIET)

Time-Out Time-Out

19 BUSY 20 DIALTONE

23 Playback Buffer Underrun 25 Fax or Data Answering Modem

Detected

27 Voice Detected

Section Seven - Event Reporting Word

Your can use the AT+VEM command to define events on which to report.

The list is encoded as a word composed of the following bits.

A 1 in a bit- position indicates an enent is reported.

A 0 in a bit- position indicates an enent is not reported.

NOTE

: Read bits from right to left..

Bit Signal Bit Signal