User Guide Voice Terminal VT1000 Series

Installation With A Single Computer

To connect your Motorola voice terminal as shown in “Sample Configuration Without A

Home Network” on page 2:

1 Be sure the Motorola voice terminal is unplugged. Be sure power is off to your

broadband modem (cable or DSL) and computer.

2 Connect one end of an Ethernet cable (RJ-45) to the Ethernet connector on your

broadband modem. Connect the other end of this Ethernet cable to the WAN

connector on the Motorola voice terminal.

3 Connect one end of another Ethernet cable to the PC connector on the Motorola

voice terminal. Connect the other end of this Ethernet cable to the Ethernet

connector on the computer.

Connect a telephone to the

LINE 1

connector using a phone wire (RJ-11). For a VT1005

or VT1005v only, you can connect a second telephone to the LINE 2 connector.

5 Power on the broadband modem, following the instructions provided with your

modem. Wait about two minutes for it to start up.

6 Plug the AC power adapter to the POWER connector on your Motorola voice

terminal and the electrical outlet. This turns your Motorola voice terminal on. You do

not need to unplug it when not in use.

Wait about two minutes for the Motorola voice terminal to start up. The POWER light

blinks as described in “Front Panel” on page 7.

Motorola voice

terminal

Broadband

Modem

Computer

WAN

Ethernet port

Phone

LINE 1