Specifications

INSTALLATION (cont.)

Plugging in the Unit (For Classic 40 ONLY)

1. Check the prongs and surface of the power cord plug for dust/dirt. If dust and/

or dirt are present, wipe off with a clean, dry cloth.

2. Check the power cord, plug and prongs for damage or excess play. If any

damage or excess play is found, contact your MovinCool reseller or a qualified

technician for repair.

WARNING:

1. If the power cord or plug is damaged, repair should only be

performed by qualified electrical personnel.

2. Do not connect/disconnect the power cord or attempt to operate

buttons with wet hands. This could result in electrical shock.

3. The power supply should be a dedicated single outlet circuit with a

UL approved short-circuit and ground fault protective breaker with

a recommended fuse size of 25 A (25 A maximum).

4. Because of potential safety hazards under a certain condition, we

strongly recommend against the use of an extension cord.

However, if you still elect to use an extension cord, it is absolutely

necessary that it is a UL listed, 4-wire grounding type appliance

extension cord, having a 4-blade grounding plug and a 4-slot

receptacle that plugs into the appliance. The marked rating of the

extension cord should be 220 V, 25 Aor equivalent.

CAUTION: The AC outlet should be rated minimum 25 A at 220 VAC, 3

phase, 60 Hz. Do not share the outlet with any other instrument or

equipment.

Note:

1. Make sure the AC outlet is free of dirt, dust, oil, water, or any other foreign

matter.

2. The Classic 40 is equipped with an approved NEMA plug configuration (L15-

30). The appropriate outlet must be used for this plug type.