Specifications

29
INSTALLATION (cont.)
Fire Alarm Control Panel Connection
(Input Signal Terminal E+ and E-)
The controller is equipped with a normal open input signal connection, which can
be connected directly from the fire alarm control panel. This input signal terminal
should only be connected to a close or open dry contact signal. When receiving
the signal from the fire alarm control panel, the unit turns off and does not turn back
on until it has been RESET.
Connecting Fire Alarm Control Panel to Controller
1. Remove three (3) screws from the upper panel on the control panel side and
open the upper panel.
2. Remove two (2) screws and plate from the right side panel.
SCREW (3)