Installation & Assembly

ManualsBrandsMR Direct ManualsBathroom Remodel & Bathroom FixturesSingle Hole Bathroom Faucet with Drain Assembly

Model 753

Vessel Faucet

Tools

Certications & Information

Configuration

Installation Guide

Connect to water supply lines with TWO

3/8" Compression Faucet Connectors

GPM

Flow Rate Chart

PSI

10 20 30 40 50 60 70 80

2.5

1.5

Faucet

Sir

Water supply

Connector

1Installation Guide

• NSF Certified

• cUPC & UPC

• ADA Approved

• Limited Lifetime Warranty

• Lead Free Construction

• WaterSense Certified

Gather the necessary tools as shown to complete the installation of this faucet.

Adjustable Wrench

Phillips screwdriver

The following tools are optional:

FlashlightSafety Glasses

Channel Lock

Pliers

1-Hole Installation

Faucet

Sir

1 3/8"

Summary of content (4 pages)

PAGE 1
Installation Guide Model 753 Vessel Faucet Certifications & Information • • • • NSF Certified cUPC & UPC ADA Approved Limited Lifetime Warranty • • GPM Lead Free Construction WaterSense Certified Flow Rate Chart 3 2.5 2 1.5 0 Tools 0 10 20 30 40 50 60 70 80 PSI Gather the necessary tools as shown to complete the installation of this faucet.
PAGE 2
Installation Guide Faucet Installation A. Turn off the water supply. Remove the faucet with the mounting hardware attatched from the package. B. Remove all mounting hardware from the shank. A B baseplate gasket washers shank lock nut mounting screws C D C. Insert optional base plate if applicable. Followed by the base plate gasket. D. Insert the shank of the faucet body into the hole of the sink deck. baseplate gasket E E.
PAGE 3
Installation Guide Pop-Up Drain Installation A. Remove pop-up drain stopper (6), and flange (7) with top rubber washer (8) from the pop-up assembly. 7 B. Insert drain body (9) from underneath of sink drain hole. Replace flange (7) and top rubber washer (8) back to drain body (9). Tighten flange securely. 6 8 7 C. Slide the bottom rubber washer (10) back on the drain pipe, up to and against the bottom of the sink.
PAGE 4
www.mrdirectint.com sales@mrdirectint.com 1-877-946-5725 Maintenance & Cleaning The faucet can be cleaned by rinsing with clear water or washing with mild detergents. Dry the faucet with a clean, soft cotton cloth. CAUTION: do not use any cleaning agents containing acids, abrasives, or other harsh chemicals. Simply rinse and dry faucets with a soft towel every week to prevent mineral deposits from forming. Clean spills and splatters as they happen.