Installation Guide

Faucet Installation
E
G
C
F
A
A. Turn off the water supply. Remove the
faucet with the mounting hardware
attached from the package.
B. Remove all mounting hardware from
the coup.
D
B
C. Insert the coup of the faucet body into
the hole of the sink deck.
D. From the underside of the sink or
mounting surface, attach the rubber ring,
followed by the steel ring and the brass
lock nut. Hand-tighten the lock nut until
secure.
E. With a phillips screwdriver, work around the
brass nut, tightening each of the three
screws in turn until all are secure.
F. Attach a 3/8" compression faucet
connector to the end of each corresponding
water supply line.
G. Attach the opposite end of each hose
to the corresponding water supply lines
by tightening the 3/8" compression ttings
onto the lines. Secure all ttings with a 1/4
turn of a wrench.
2
Installation Guide
coup
sink deck