Owner manual

3
IMPORTANT!
Keep hose as short as possible when
routing. Hose must not kink, crimp, contact
hot exhaust or sharp surfaces, otherwise
damage to hose or engine will result. A
minimum 3-1/2” radius bend is suggested
when routing, or oil flow restriction will
occur.
Hoses connected to by-pass adapter
ports marked “in” and “out” must
correspond to the same “in” and “out”
ports on the remote oil filter mounting
bracket for proper oil circulation.
Check hoses to be sure they are
connected correctly.
Single Remote Oil Filter System Installation
Typical
Installation
Shown
www.mr-gasket.com
3-1/2 min.
bend radius
3-1/2 min.
bend radius
IN OUT
IN OUT