Use and Care Manual

4
Mr. Heater | Portable Buddy Flex Cooker Operating Instructions and Owner’s Manual
NEVER LEAVE THE COOKER UNATTENDED WHILE BURNING!NEVER LEAVE THE COOKER UNATTENDED WHILE BURNING!NEVER LEAVE THE COOKER UNATTENDED WHILE BURNING!
Lighting Instructions
ALWAYS ATTACH OR DETACH
CYLINDER TO HEATER OUTDOORS
AWAY FROM FLAMES, OTHER IGNITION
SOURCES, AND ONLY WHEN COOL
TO TOUCH. NEVER SMOKE WHEN
ATTACHING OR REMOVING PROPANE
CYLINDER OR MAKING REMOTE
CONNECTIONS!
IMPORTANT: The cooker must not be
exposed to flammable vapors or liquids
during lighting.
1. Follow instructions in Buddy Flex
Heater manual to attach cooker to
heater (as shown in Figure 1) and to
pre-light the heater.
IMPORTANT:Check quick connection
for leaks with soapy water. DO NOT
USE ANY EXPOSED FLAME TO CHECK
FOR LEAKS.
2. Push control knob slightly and rotate to
“LOW/START” position. See Figure 2.
3. Push down and hold control knob in
while pressing ignition button.
4. Hold control knob down for 5-30
seconds to activate thermocouple,
until burner sustains flame.
5. Once flame is sustained, rotate control
knob to adjust flame to desired
setting.
1
2
Ignition Button
Figure 1
Figure 2
Figure 3Figure 4
Shutdown Instructions
1. To shut off cooker, shut off the heater
gas supply first, then rotate the cooker
control knob to the “OFF” position.
Do not operate, store or remove
cylinder near flammable items or
ignition sources.
LP-GAS CYLINDERS MUST BE
DISCONNECTED FROM HEATER WHEN
NOT IN USE!
Pulse Ignition
The Pulse Ignition Button is located to
the left of the control knob. Refer to
Figure 2.
Open the battery cover located on the
bottom of the cooker to install
the “AAAbattery (included).
Transporting Cooker
Your Buddy Flex Heater and Buddy Flex
Cooker are specially designed to easily
move around as a single unit.
To attach the cooker to the heater:
1. Place the heater on top of the cooker
as shown in Figure 3.
2. Lift up engagement flap to engage
each rail and then fold it down to
secure the cooker to the heater.
See Figure 4.
OPERATION