AromaSteam Installation Sheet

mr
.
steam
®
AromaSteam Operation and Installation Instructions
______________________________________________________________________________________________
5
Installation of Suction Hose to
AromaSteam System
1. Unscrew the suction end nut from the pump head.
2. Assemble the tubing connection as shown in figure
1 on page 4.
3. Screw the suction tube tightening nut to the suc-
tion side of the pump
IMPORTANT NOTE: HAND-TIGHTEN ONLY.
iSteam
Steam Line
Typical Mr.Steam
Steam Generator
Request Cable
Atomzer Nozzle
Pressure Hose
90˚ T
Suction Hose
Essential Oil Container
Pump Line Cord 120V
(grounded receptacle required)
AromaSteam
System
UTILITY
ROOM
STEAM ROOM
Steam Head
M
a
x
D
i
s
t
a
n
c
e
1
0
f
t
.
Max ht: 6 ft.
Max ht: 6 ft.
Typical AromaSteam Installation
FOR USE WITH AIRTEMPO
®
,
iSTEAM
®
AND iTEMPO/PLUS
®
CONTROLS ONLY
Locate the AromaSteam system
to monitor the consumption of
essential oils and for easy
oil replacement.
NOTE: CABLES SHOULD
NOT CONTACT STEAM PIPE.
For illustrative Purposes Only
Pressure Hose
Repeat the suction hose installation steps on the
p
ressure side of the pump.
MrSteam recommends installing the AromaSteam
lower than the Atomizing nozzle. If the pump must be
installed higher that the atomizing nozzle a loop
should be placed in the pressure tubing to prevent
siphoning as required. An air
bubble should be trapped
at the top of the loop.
Pressure Tube
Pressure Tube
Tightening Nut
Priming Port Valve
Priming Port
Suction Tube
Tightening Nut
Suction Tube
Figure 4