Installation, Operation & Maintenance Manual AromaSteam mr.steam l ® Feel Good Inc.
mr.steam ® AromaSteam Operation and Installation Instructions ______________________________________________________________________________________________ ! WARNING RISK OF ELECTRIC SHOCK - This pump is supplied with a grounding conductor and grounding-type attachment plug. To reduce the risk of electric shock, be certain that it is connected only to a properly grounded, grounding-type receptacle.
mr AromaSteam Operation and Installation Instructions .steam ______________________________________________________________________________________________ ® BOX CONTENTS 8 ft. Pressure Hose 1/4 x 1/2 NPT Atomizing Nozzle Injector AromaSteam System (with integrated 6 ft. power cord, 8 ft.
mr AromaSteam Operation and Installation Instructions .steam ______________________________________________________________________________________________ ® GENERAL INSTALLATION (cont.) Tubing Figure 1 Clearance to heat sources • Do not install the AromaSteam system directly below or above the MrSteam steam generator where it is subject to heat. • Minimum distance between the AromaSteam system and a heat source (e.g. steam generator, heating system) is 1.5 ft. If this minimum distance of 1.
mr AromaSteam Operation and Installation Instructions .steam ______________________________________________________________________________________________ ® Installation of Suction Hose to AromaSteam System Pressure Hose Repeat the suction hose installation steps on the pressure side of the pump. 1. Unscrew the suction end nut from the pump head. MrSteam recommends installing the AromaSteam lower than the Atomizing nozzle.
mr AromaSteam Operation and Installation Instructions .steam ______________________________________________________________________________________________ ® Electrical Connection of AromaSteam System ! AromaSteam Wiring Schematic AromaSteam Plug CAUTION This AromaSteam system is factory wired. If the power cord of the Aroma Steam system is damaged it must be replaced by the Sussman-Automatic service department or similarly qualified personnel in order to avoid an electric shock hazard.
mr AromaSteam Operation and Installation Instructions .steam ______________________________________________________________________________________________ ® OPERATION Powering Up the Pump IMPORTANT NOTE: This step only needs to be performed during installation. Aromatic Setting Knob 1. The pump needs to be turned on before it can be used 2. Press and hold the power button for 2 seconds. The LED will turn on solid red.
mr AromaSteam Operation and Installation Instructions .steam ______________________________________________________________________________________________ ® TROUBLESHOOTING TECHNICAL SPECIFICATIONS LIST OF SPARE PARTS Description Part No. Metering pump does not prime Pump Head Pressure/Suction Hose 104239 104255 1. Check if voltage is available. (ordered by the foot) 2. Check liquid level in scent container. Replenish liquid, if necessary.