Instructions / Assembly
ITEMPO INSTALLATION
16
ITEMPO
®
OR ITEMPO/PLUS
®
CONTROL INSTALLATION
IMPORTANT: Turn power to the steam
generator OFF before installing the control.
Failure to turn the power off will result in an
inoperable control.
1. Firmly connect the control cable to the control.
Turn on power to the steam generator and test
the control to verify correct connections.
Test per instructions. Proceed with installation
and verification of proper control function.
2. Remove & discard peel-off paper to expose
adhesive liner.
3. Run a bead of silicone on reverse side edge of
iTempo control (silicone provided).
4. Insure the mounting surface is clean and dry as
required for good adhesion. Apply silicone into
the hole in the wall as required to create a
moisture seal. Hold the control with the LED
display in the 12 o’clock position and press the
control against the wall until the adhesive sticks
and holds firmly as shown above.
IMPORTANT The information in this guideline is designed to provide a general overview of how MrSteam products are installed. The diagrams are for Illustrative purposes only. NEVER use this document for the Installation,
Operation or Maintenance of any MrSteam product. For Installation, Operation and Maintenance information, only use the specic Installation, Operation and Maintenance manual supplied with each Mr. Steam product. The
specic Installation, Operation and Maintenance manual that is supplied with each Mr. Steam product contains important information required for the safe and reliable installation and operation of the product. Failure to use
the specic Installation, Operation and Maintenance manual that is supplied with each Mr. Steam product may result in product damage, property damage, death or personal injury. If you do not have an Installation, Operation
and Maintenance manual please contact MrSteam for a free copy, or download a copy from www.mrsteam.com. If you have any questions about the installation, operation or maintenance of any MrSteam product please
contact a customer or technical service representative using the contact information on the back cover of this guideline.