Instructions / Assembly

2525
CHROMA72 INSTALLATION
CHROMASTEAM 72 INSTALLATION
Light Fixture
LED Cluster
For Illustrative purposes only. Consult with qualified designer,
architect or contractor for steamroom construction details.
1. Determine the placement of the light.
Do not install the xture assembly (light) where direct contact with
steam or water emission could occur. Do not install the light in a location
where it could become submerged.
2 . The light requires a 41⁄4”diameter hole for mounting.
3. Provide electrical service (120VAC) with exible cable
only. Pass cable through ceiling opening and wire xture
in accordance with NEC and local electrical code.
DO NOT install the wall switch in the steam room. The switch
must be installed in a location and manner described in the NEC
and local electric codes. Do not use a dimmer switch to control
the ChromaSteam Lights.
4. Route the 30 foot cable supplied with the Chroma
Steam from your steam bath generator through one
of the knockouts in the ChromaSteam light wiring box.
Provide a suitable strain relief bushing.
IMPORTANT NOTE: The quick connect tabs should be on the generator
side, the Molex connector should be routed to the light, see gure2.
5. Connect the quick connect tabs to the control board
in the generator at the location marked CHROMA,
see gure 4.
6. Remove the red jumper wireshown in gure3 and
discard. Connect the wire from the steam generator to
the connector where the jumper was.
7.Connect the supply wires. Use suitable wirenuts (not
included) to insulate and secure the supply connections.
8.Connect copper ground wire from wiring box to
ground wire from electrical service using a wire nut to
secure the connection.
9.Use the support adjustment screw shown to provide
support for the housing on the inside surface of the
ceiling when installed.
10.With the clips folded into th exture as shown in
gure 1 insert the wired housing into the ceiling junction
box rst as shown in gure2.
NOTE: for mood lighting only.
The ChromaSteam System is not a substitute for general
illumination. Consultation with architect, designer and/or
contractor on room design and construction is strongly
recommended.
TO GENERATOR
TO LIGHT
Figure 1
Figure 2
Figure 3
Figure 4
IMPORTANT The information in this guideline is designed to provide a general overview of how MrSteam products are installed. The diagrams are for Illustrative purposes only. NEVER use this document for the Installation,
Operation or Maintenance of any MrSteam product. For Installation, Operation and Maintenance information, only use the specic Installation, Operation and Maintenance manual supplied with each Mr. Steam product. The
specic Installation, Operation and Maintenance manual that is supplied with each Mr. Steam product contains important information required for the safe and reliable installation and operation of the product. Failure to use
the specic Installation, Operation and Maintenance manual that is supplied with each Mr. Steam product may result in product damage, property damage, death or personal injury. If you do not have an Installation, Operation
and Maintenance manual please contact MrSteam for a free copy, or download a copy from www.mrsteam.com. If you have any questions about the installation, operation or maintenance of any MrSteam product please
contact a customer or technical service representative using the contact information on the back cover of this guideline.
Note: ChromaSteam72 is not for use with the iSteam3 control.