Installation Manual

Page 22mrcool.com
Outdoor Unit Installation
Outdoor Unit Dimensions: inches (millimeters) Mounting Dimensions inches (millimeters)
Width (A) Depth (B)
20.24 in
(514 mm)
13.39 in
(340 mm)
21.26 in
(540 mm)
13.8 in
(350 mm)
20.24 in
(514 mm)
13.39 in
(340 mm)
26.5 in
(673 mm)
15.87 in
(403 mm)
19.2 in
(487mm)
11.73 in
(298 mm)
21.26 in
(540 mm)
13.8 in
(350 mm)
20.24 in
(514 mm)
13.39 in
(340 mm)
33.27 in x 27.64 in x 14.29 in
(845 mm x 702 mm x 363 mm)
37.24 in x 16.54 in x 31.89 in
(946 mm x 420 mm x 810 mm)
30.31 in x 21.85 in x 11.81 in
(770 mm x 555 mm x 300 mm)
31.50 in x 21.81 in x 13.11 in
(800 mm x 554 mm x 333 mm)
31.50 in x 21.81 in x 13.11 in
(800 mm x 554 mm x 333 mm)
31.50 in x 21.81 in x 13.11 in
(800 mm x 554 mm x 333 mm)
37.24 in x 31.89 in x 16.14 in
(946 mm x 810 mm x 420 mm)
33.27 in x 27.64 in x 14.29 in
(845 mm x 702 mm x 363 mm)
26.63 in
(676 mm)
16 in
(404 mm)
O-HH-09-HP-C-230
O-HH-18-HP-C-230
O-HH-12-HP-C-230
O-HH-24-HP-C-230
O-ES-09-HP-C-230
O-ES-18-HP-C-230
O-ES-12-HP-C-230
O-ES-24-HP-C-230
W
H
D
Air Inlet
A
B
Air Outlet
Air Inlet
Fig. 4.6
If you will install the unit on the ground or on a
concrete mounting platform, do the following:
1. Mark the positions for four expansion bolts based
on dimensions in the Unit Mounting Dimensions
chart above.
2. Pre-drill holes for expansion bolts.
3. Clean concrete dust away from holes.
4. Place a nut on the end of each expansion bolt.
5. Hammer expansion bolts into the pre-drilled holes.
UNIT MOUNTING DIMENSIONS
Prepare the installation base of the unit according to the dimensions below.
When drilling into concrete, eye
protection should be worn at all times.
6. Remove the nuts from expansion bolts, and
place outdoor unit on bolts.
7. Put washer on each expansion bolt, then
replace the nuts.
8. Using a wrench, tighten each nut until snug.
Step 3: Anchor outdoor unit - single-zone (Hyper Heat & E Star)