Installation Instructions

INSTALLATION

1. Apply a premium grade white thin-set mortar using a 3/16 inch V-notch trowel.

2. Set tiles, apply pressure or tap the surfaces with a rubber grout float to ensure all tiles

are bonded and aligned properly. Use a level periodically to check the grout joints.

3. After 24 hours, mix and apply grout. (Read important information below)

 Tiles with metal or glass-USE UNSANDED GROUT

It is very important to understand any abrasive materials or chemicals can

scratch the surface of your tile.

 Natural stone and ceramic-USE SANDED GROUT

4. Clean all excess grout immediately with a damp sponge. After 12 hours polish any

remaining grout haze with clean dry cloth.

CUTTING

A wet saw is recommended to cut mosaic tiles. A premium glass

Diamond blade is recommended for glass cutting. Other mosaics such as ceramic,

Natural stone and metal use a standard diamond blade.

SEALING

Mosaics containing natural stone should be sealed prior to grouting.

Use a premium penetrating sealer for a natural look. To darken and

Highlight the natural elements of the stone, use a stone enhancing sealer.

Never allow sealers to dry on glass, glazed ceramic or metal.

CARE AND CLEANING

Use a soft cloth or sponge with warm water or any non-abrasive mild.

PAGE 1
INSTALLATION 1. Apply a premium grade white thin-set mortar using a 3/16 inch V-notch trowel. 2. Set tiles, apply pressure or tap the surfaces with a rubber grout float to ensure all tiles are bonded and aligned properly. Use a level periodically to check the grout joints. 3. After 24 hours, mix and apply grout. (Read important information below) Tiles with metal or glass-USE UNSANDED GROUT It is very important to understand any abrasive materials or chemicals can scratch the surface of your tile.