International Computer Hardware User Manual

CX-MB-EVA2 User's Manual Hardware

4.8 TV Out

A TV-OUT connector is implemented for displaying the video signal on a TV set (or the

like). The base board supports the following video signals

 Composite Video

 Component Video (YPbPr)

 S-Video

The type of the video signal is defined by the graphics controller on the COM Express

module.

Specification:

 References: X17

 Connector: AMP 5786766-1

 Pinout: Refer to Table 6

Pin Signal name Composite Component S-Video

1 TV_IRTN_B Ground Ground Ground

2 TV_IRTN_C Ground Ground Ground

3 TV_DACB not used Luminance (Y) Luminance

4 TV_DACC not used Chrominance (Pr) Chrominance

5 TV_DACA CVBS Chrominance (Pb) not used

6 TV_IRTNA Ground Ground Ground

7 RSVD reserved reserved reserved

Table 11 Pinout TV-Out

The signals can be adapted to a different interface with a 10-pin header.

Specification:

 References: X53

 Connector: IDC-M 10pol. THT RM2.54

 Pinout: Refer to Table 7

Pin Signal Pin Signal

1 GND 2 TV_DACA

3 GND 4 TV_DACB

5 GND 6 TV_DACC

7 GND 8 GND

9 GND 10 GND

Table 12 Pinout TV-Out Pin header