International Computer Hardware User Manual

CX-MB-EVA2 User's Manual Hardware

4.9.2 HDA codec

Specification:

 References: X39

 Connector: Foxconn JAS331-H1G2-4F

 Pinout: Refer to Table 12

Con colour Function

1 light blue

Line In

2 lime Line Out

3 pink Mikrofon

4 orange Center / LFE

5 black Surround

6 grey Side

Table 17 Pinout LineOut

4.10 IDE Interface

A standard IDE interface is provided according to ATA/ATAPI, with the controller

supporting at least Ultra-ATA100 with 100 MB/sec data rate. The transfer mode that can

be selected depends on the cable used and which modes are supported by the drives.

Using a ATA100 cable on X22, avoid a master slave combination with X23 or X24.

4.10.1 Primary IDE Channel

4.10.1.1.1 40-pin IDE interface

A 40-pin IDC connector is provided at the primary IDE channel for standard IDE drives.

Specification:

 References: X22

 Connector: FCI 75869-118

 Pinout: Refer to Specification ATA/ATAPI-6 [6, page 400, Table A3]

4.10.1.1.2 44-pin IDE Interface

For connection of 2.5” hard disks, a 44-pin IDC connector is provided at the primary IDE

channel.

Specification:

 References: X23

 Connector: Yamaichi ZP7-44-S-G

 Pinout: Refer to Specification ATA/ATAPI-6 [6, page 412, Table A16]