Installation Guide

7
A. Site Requirements
WARNING: The floor has to be capable of supporting the expected load.
WARNING: An adequate drainage system has to be provided to deal with overflow water.
IMPORTANT: Because of the combined weight of the spa, water and users, it is extremely important that
the base where the spa is installed is smooth, flat, level and capable of uniformly supporting the weight for
the entire time the spa is installed. If the spa is placed on a surface which does not meet these require-
ments, any damage caused by improper support will void the warranty. It is the responsibility of the spa
owner to ensure the integrity of the site at all times.
Be aware of special requirements if you install the spa indoors.
1. The floor must be able to withstand the capacity of the spa.
2. The floor should be a non-slip, level surface.
3. Proper drainage is essential for indoor spa installation.
4. When building a new room for the spa it is recommended that a floor drain be installed.
5. Humidity is naturally present with the spa installation, determine the effects of airborne moisture on ex-
posed wood, paper, etc. in the proposed location.
6. To minimize these effects it is best to provide plenty of ventilation to the selected area. An architect can
help determine if more ventilation is needed.
NOTE: Do not install the spa on carpet or other material that can be damaged by moisture.
B. GFCI Test
WARNING: RISK OF ELECTRIC SHOCK. The GFCI plug must be tested before each use.
WARNING: Insert the GFCI plug into a residual current device (GFCI) protected power receptacle only.
WARNING: Before inserting the plug into a power receptacle, make sure the current rate of the power
receptacle and the fixed wiring are suitable for the spa. Contact a qualified electrician, if you cannot distin-
guish.
1. Insert the plug into the power receptacle. (1)
2. The indicator light should turn red.
3. Then press the “TEST” button. The indicator light should disappear. (2)
WARNING: Do not use if above test fails.
4. Press the “RESET” button again, the indicator light should turn red. The spa is now ready for use. (3)
)3()2()1(
RESET
TEST
RESET
TEST