Installation Guide

8
C. Assembly
a) Unfold the Spa pool from the packaging. Spread the Spa, cover and temp barrier mat. Make sure
Spa and cover are right side up. Put temp barrier mat under Spa(optional).
Temp barrier mat(optional) is helpful to avoid heat loss from bottom and provide better heat preservation
together with inflatable bladder(optional) being used.
It’s only possible to setup and leave the spa at outside temperature less then 4°C(40°F) as long as the spa
has a constant water temperature guaranteed more then 4°C(40°F). The spa can be used under low
environment temperature down to maximum -10°C(14°F) if it is properly set up to make sure no frozen water
inside control box, pipes and spa pool. It’s helpful to put temp barrier mat between spa and ground, or similar
mat which is made of foam material or some material with temp barrier function.
b) Screw the control panel onto the spa, fasten the ring to the pipe adaptor.
c) Connect the pin plugs. Make sure that plugs are properly matched together, then screw a cap, and then
you’ll see code shown on control panel, no bent or wet for the pin inside male connector which will cause
failure connection.
d) Open the air valve under the control panel. Screw one end of inflation hose onto it.
e) Unscrew the top part of air valve on the Spa. Screw the other end of inflation hose onto Manometer, and
then put into the air valve.
f) As previously outlined, test spa’s GFCI plug. Then inflate the spa pool by pressing the “bubble” button.
For models coming with outer pool cover, put the side leather cover on the spa tub.
Attention: make sure the 2 holes on the leather fit the right positions of spa tub.
(c)
(b)
(d) (e)
(f)
1 0 0
NOTE: Unscrew this stopper for deflation
of the spa pool.
After complete deflation, screw the
stopper onto the spa pool again.
Valve
Unscrew
Don’t install Mspa onto the lawn as grass may cause air
pump damped and rusted which could result the air pump
works improperly and will void your warranty.
Precautions:
1. When using the spa tub outside, air pipe can not be taken off. Do not use
the spa tub in rains as air pump will not working properly.
2. The two O-ring part on the air pipe is important to get the spa tub working
properly. Lost of the O-rings could cause air pump rusted or not working properly.
Missing of the O-rings also affects bubbling function.
Note: B-100 includes a side bar, which needs to be placed before filling water to the tub. The side
bar helps keeping the spa pool in its proper shape after filling.