Owner Manual

Installation and Operational Manual
°
Designer Collection
°
Acrylic Freestanding Tubs
11 / mtibaths.com
Operation Instructions - Combined Therapy
Standard Airbath
#1 System
Airbath with Radiance®
#1R System
ON/OFF
1st Press: The blower starts. LED indicator light on.
2nd Press: The blower stops. LED indicator light o.
NOTE: Blower automatically stops after 20 minutes.
Blower speed increase
Press & hold to increase the blower speed. Release pressure at the desired speed.
NOTE: The blower initially starts at 30% speed.
Blower speed DEcrease
Press & hold to decrease the blower speed. Release pressure at the desired speed.
Spa Modes
1st Press (Wave): Speed will vary gradually from maximum to minimum. LED indicator light is on.
2nd Press (Pulse): Speed will go directly to minimum and then straight back to maximum. LED indicator light will flash.
3rd Press: Returns to maximum speed. LED indicator light o. Press button #3 to decrease blower speed.
ON/OFF for radiance
1st Press: Turns on both heated zones LED indicator light on.
2nd Press: Turns o Radiance system. LED indicator light o.
See Standard Airbath above for operation instructions for the remaining buttons.
NOTE: The blower initially starts at 30% speed.
Standard Drying Cycle with water detectors
Sensors on the floor near the drain will activate the drying cycle approximately 7 minutes after the bath is drained and run
for 1-2 minutes. The drying cycle will activate even when the air system has not been turned on. The blower LED blinks (on
keypad only) during the drying cycle countdown. This countdown cannot be cancelled. Any attempt to cancel this cycle only
resets the countdown timer.
Operational Videos
Please visit mtibaths.com/support/installation-operation/ for detailed operation instructions.