Owner Manual

Installation and Operational Manual
°
Designer Collection
°
Acrylic Freestanding Tubs
13 / mtibaths.com
Operation Instructions - Combined Therapy
Keypad style and functions may vary
according to tub model and selected
options. See product specification
sheet for details or contact MTI Baths.
Spa Mode (Air Only)
Airbath Elite with Spa Mode
#4 Digital System
Spa Modes
1st Press (Wave): Speed will vary gradually from maximum to minimum. LED indicator light is on.
2nd Press (Pulse): Speed will go directly to minimum and then straight back to maximum. LED indicator light will flash.
3rd Press: Returns to maximum speed. LED indicator light o. Press button #3 to decrease blower speed.
ON/OFF
1st Press: The blower starts. LED indicator light on.
2nd Press: The blower stops. LED indicator light o.
NOTE: Blower automatically stops after 20 minutes.
Blower speed increase
Press & hold to increase the blower speed. Release pressure at the desired speed.
NOTE: The blower initially starts at 30% speed.
Blower speed DEcrease
Press & hold to decrease the blower speed. Release pressure at the desired speed.
on/o: Chromatherapy
1st Press: Turns on basic color mode of bath lights, starting with white. Use up and down arrows to move light through
basic colors.
2nd Press: Turns on slow rainbow cycle. Use up and down arrows to increase or decrease speed of cycle.
3rd Press: Slow aqua-blue-green cycle. Use up and down arrows to increase or decrease speed of cycle.
Press & hold light button at any time to turn o Chromatherapy feature.
spa mode (air & lights)
1st Press: Turns this Spa Mode on. There are three dierent full system Spa Modes with this feature that range from
Relaxing, Energetic, to Deep Tissue. Use the up and own arrows to choose from the dierent selections. Each Spa Mode
will operate tub functions automatically for 20 minutes. Simply sit back and enjoy.
2nd Press: Turns this Spa Mode o.
Operational Videos
Please visit mtibaths.com/support/installation-operation/ for detailed operation instructions.
Standard Drying Cycle with water detectors
Sensors on the floor near the drain will activate the drying cycle approximately 7 minutes after the bath is drained and run for 1-2 minutes.
The drying cycle will activate even when the air system has not been turned on. The blower LED blinks (on keypad only) during the drying
cycle countdown. This countdown cannot be cancelled. Any attempt to cancel this cycle only resets the countdown timer.