Computer Hardware User Manual

2 - 4
computer as instructed in your
computers documentation.
3 Locate the unused slot(s) which
you will be using for your ISI
card, and remove the slot
cover(s) per the instructions in
your computers documentation.
4a The figure below shows the
default settings for this card.
Record any changes made to
the Base I/O Address settings.
The default Base I/O Address is
2F8 (COM2). The valid range is
100H - 3F8 H; refer to Appendix
A for a full table of address
settings.
O(pen) = OFF
C(losed) = ON
Figure 2-2. I/O Address Default
Table 2-1 (cont'd)
Step Procedure
ISI Configuration and Installation Procedure