- Multi-Tech Broadband Router User Guide

Chapter 5 – RouteFinder Manager
RouteFinder RF500S User Guide 89
Interface: Select the port (LAN or WAN, etc.) that the routed packet should pass
through. Select
Local Network if you are using a separate router. If you are using
the RF500S with the LAN-to-LAN function, the Interface should be set as the WAN
port that connects you to the other subnet.
Click
Insert to save the information to the routing table. To delete this information,
select it from the routing table and click the
Delete button.
Default Gateway
Gateway: The Default Gateway is an IP address that all packets are routed to,
when the device is unable to find a route match (the destination IP address of the
packet in the routing table). Click the
Add Default Gateway button to save the IP
address of the default gateway.
Interface: Select the port (LAN or WAN, etc.) interface where the gateway is
located.
Dynamic Routing
This feature is not available.