Installation manual

ISI3334/4 Hardware/Driver Installation Manual
24
Table 3-2 (cont'd)
Step Procedure
5 The ISI Card Port Count dialog box appears. Click on the
number of ports you are installing, and then click on Next.
6 The Destination Directory dialog box appears. Click on Next to
accept the default Destination Folder , or click on Browse to
choose another location. When you are finished, click on Next
to continue with the installation.
7 The Start Copying Files menu appears. Click on Next to proceed
with the installation, or click on Back to go back and change the
parameters you have set.
8 The following message appears:
Adding ISI Ports. This will take a few minutes.
Click on OK to proceed.
Click on OK to proceed.
9 The following message appears:
ISI card was successfully installed. You need to
set the base address and IRQ for the card. Please
select the MultiTech ISI Card under MultiPort, in
Device Manager and then select the Properties to
change the settings.
Click on OK to continue.
10 The System Properties menu is displayed. Highlight MultiTech
ISI Card and click on Properties.
11 In the MultiTech ISI Card Properties menu, click on Resources |
Set Configuration Manually.
12 The software defaults to a setting of I/O Address = 200, IRQ = 3.
However, the factory default setting for all ISI Cards is I/O
Address = 210 and IRQ = 10.
Highlight Input/Output Range and click on Change Setting.
Select the proper I/O range from the drop-down value list
(choose 210-217 to match the default setting for the ISI card)
and click OK.