Installation manual

Chapter 3 - MultiModemISI Driver Installation
27
3.4 Installation in SCO Open Server 5
The installation utility provided by SCO is called custom . This section
is a brief guideline for invoking the utility and installing the driver. The
instructions contained in the following table should only be used on
SCO Open Server 5 systems. When you have completed the steps
in Table 3-3, you will be directed to the Installation Script section of
this chapter for a discussion of the Multi-Tech Installation Script.
Table 3-3
ISI Driver Installation for SCO Open Server 5
Step Procedure
1 If you are installing the driver from your default floppy drive, type
custom and press <Enter> to invoke the custom utility. If you
are using a non-default drive, you must inform your system of
the disk drive from which you will be doing the installation and
the size and capacity of the diskette(s).
2 Highlight Software and press <Enter>
3 The main menu displays a screen with options. The Install
option should be highlighted, so press <Enter>. You can move
around the screen by using the cursor keys (e.g., up/down
arrows). If the option you are instructed to select is not
highlighted, use these keys to position the highlight bar over the
appropriate option, and then press <Enter..
4 Highlight From comsco and press <Enter>
5 Be sure that the driver diskette is in the floppy drive and then hit
"Enter" to select the highlighted (default) selection, Floppy Disk
Drive 0. The following message is displayed:
Examining media. Please wait ...