Installation manual

Chapter 3 - MultiModemISI Driver Installation

3.5 The Multi-Tech Installation Script

This section guides you through the Multi-Tech Installation Script for

SCO and UNIXWare systems. The script requests such information

as how many boards you want to install, what I/O address and IRQ

values (interrupt request) you have selected and how many pseudo

devices you want to create for Multi_View utility. This information

extracts the necessary drivers, which will be linked with your

system's kernel.

Table 3-4

Multi-Tech Installation Script

Step Explanation

1 The first screen requests the number of ISIs you are installing.

If you have more than one ISI, we recommend using the chart in

Table 2-1 in Chapter 2, so that you input the appropriate values

for each card.

Input the number of cards, and press <Enter>.

2 The second screen requests the following:

Enter Number of ports for ISI Board 1 (8 or 16):

Enter 8 and press <Enter>

3 The third screen requests the base I/O address you have

selected for the first card you are installing.

It is important to verify that the address you select for each ISI

does not overlap with existing devices or with another ISI. The

ISI cards use the base I/O address and the next fifteen

addresses.

Note: If the I/O address you select conflicts with an existing

device in your system, you must remove the ISI driver and re-

install it.

Supply the base I/O address, and press <Enter>.

For additional information, return toChapter 2 and/or to Appendix