Installation manual

Chapter 3 - MultiModemISI Driver Installation
31
Table 3-4 (cont'd)
Step Explanation
7 To change the name type N and provide a prefix of less than 5
characters. The base name you select will be used for all ports
on each card you install.
The following information describes the format used in naming
the ISI ports:
Default device name and format: ttyl
ttyl BASENAME
This prefix is applied to all ISI ports on all boards. Base names
are 1-4 characters
b BOARD NUMBER
Values of 1 through 4, depending on the number of ISIs
installed.
x PORT LETTER
Values of A-H for ISI ports. (SCO UNIX/XENIX values A-H
indicate modem ports.)
Device Base Name Selected: _________________
8 Once you have selected a device base name, you are prompted
for a printer base name. This prefix is used to identify each port
that supports a terminal with a printer attached to its auxiliary
port (for transparent printing). You can select a unique base
name, or you can accept the default of “ prnl ” (printer parameters
are outlined in the Multi_Setup Utility section in this chapter).
Printer Base Name Selected: _________________
9 The Multi_View utility initializes the multiple-page capability of
terminals with multiple pages of memory. You are asked how
many pseudo devices (which is the total number of pseudo
devices you wish to make available to the Multi_View utility) to
create. This is the total number of devices available to all Multi-
Tech's terminals. You can have a maximum of 256 pseudo
devices in your system.