Network Card User Manual

21-IWay Hopper
Installation
4. If you already installed the ISDN Accelerator Pack 1.1 (MSISDN11.EXE), then
go to the next setup section. To update the Dial-Up Networking to support 2B
channel (MLP) connection and NDISWAN Miniport interface you will need to
install the Win95 MSISDN11.EXE (version 1.1 or above) upgrade pack. You
can get the file from our Windows 95 installation diskette and it is also acces-
sible from Microsofts web site. Run the MSISDN11.EXE program and fol-
low the installation instructions.
5. Reboot your PC to enable the ISDN Accelerator Pack.
2.6 NDISWAN and Virtual Modem Interface Connections
After you complete the ISDN driver installation, you can execute applications
based on the WinISDN and CAPI interfaces. Of course, you must install the soft-
ware before interface operation. See Appendix B for RVS-COM (lite version)
software installation, and follow this installation procedure example. In Windows
3.1, you need to run the AT Console to enable the COM port emulation capability.
Under Win95 the COM port emulation is automatically loaded at startup.
You can make a NDISWAN or virtual modem selection to connect to the Internet
or a remote LAN. If you wish to execute Internet related applications or RAS, we
suggest that you setup and use the NDISWAN Miniport adapter interface. Using
the NDISWAN Miniport driver is the Microsoft preferred connection method.
If you want to execute the current modem applications, (e.g., HyperTerminal or
PCAnywhere), set up and use the virtual modem interface through our COM port
emulation function (the virtual modem).
1. For connection through the NDISWAN Miniport Adapter, you must have the
Microsoft ISDN Accelerator Pack 1.1 (MSISDN11.EXE) installed. Add the
NDISWAN Miniport driver. Double Click on Start»Settings»Control
Panel»Network»Add»choose Adapter»Add»Have Disk. Specify the directory
for the iinwan95.inf file (under installation diskette of NDISWAN directory,
e.g. A:\NDISWAN), click OK.