Network Card User Manual

Introduction/Description
8-IWay Hopper
Your internal ISDN PC card is compatible with prevalent ISDN switch protocols.
It communicates using ISDN BRI (2B+D) service, which provides up to 128K bps
data communications.
This manual documents the following models:
 MT128ISA-SD for ST interface no POTS port
 MT128ISA-SV for ST interface with one POTS port
 MT128ISA-UD for U interface no POTS port
 MT128ISA-UV for U interface with with one POTS port
All of the current analog devices, including telephone set, G3 fax, answering ma-
chine, modem, and PBX trunk line, can be connected to the POTS port via an RJ-
11 jack in V models.
This owners manual will help you install, configure, and operate your TA.
1.2 Features
Your internal ISDN PC card features include:
 D Channel protocols. Including AT&T 5ESS, Nortel DMS-100, US NI-1 &
NI2, ETSI, Japan INS-64
 B Channel protocols. Including HDLC, X.75, V.120, and voice (V models)
 ISDN BRI (2B+D) and analog ports.
 Supports Application Interfaces including WinISDN, CAPI 2.0, Windows
Comm (AT command/S-Registe/Result Codes) and NDISWAN Miniport.
 Automatic detection of incoming calls as voice or data (V models).
 Supports Windows 3.1, Windows 95 (OSR-2), and Windows NT Multilink PPP
connection.
 Supports Microsoft ISDN Accelerator Pack.
 PnP compatibility with 16 bits address decoding.
 Ability to use the same communications software as analog modems
 Provides On-line test and Diagnostics tools.