User guide

10
MultiArray User Guide
Unpacking
Check the items on the MultiArray shipping list to ensure that you have received the correct
accessories. Your MultiArray should include:
• MA3a chassis (with included CD-ROM and floppy drives)
• Two AC power cords
• Accessory kit (with jumper cards and ribbon cables)
• Driver diskette
• This Quick Start Guide
• User Guide diskette
• Tucows® accessory CD
Unpack and inspect the MultiArray rack for visible shipping damage. If damage is observed, do
not power-on the rack; contact Multi-Tech's Tech Support for advice (refer to Chapter 5 for
information on service and support). If no damage is observed, place the rack on a flat, stable
surface to begin installation and configuration.
Save the packing material for possible future use (e.g., return or relocation).
Safety Warnings
1. Both power cords must be unplugged to remove all power from the chassis. Each
redundant power supply has it’s own power cord and supplies power to various
components in the chassis. Therefore, both power supplies must be powered on for the
system to operate properly.
2. The power supply cords are intended to serve as the disconnect device. The outlet
sockets must be installed near the equipment and be easily accessible.
3. To reduce the risk of shock, all openings should be covered during normal operation of
equipment.
4. If the battery fails on the SBC and it needs to be serviced, refer to your SBC manual for
shipping instructions.
5. All servicing to be done by qualified personnel only.