User guide

MultiArray User Guide

Disk Drive Installation

Installing Drives in the 8-Bay Disk Drive Chassis

1 Open the front door on the rack.

Note: Although you can remove the front door for installation purposes, you must replace the

door prior to applying power to the unit.

2 Remove the two top front drive chassis mounting screws. See Figure 2-7.

3 Loosen, but do not remove, the two rear drive chassis mounting screws. See Figure 2-7.

Front Drive Chassis

Mounting Screw

Rear Drive Chassis

Mounting Screw

Figure 2-7. 8-Bay Drive Chassis Mounting Screws

4 Slide the chassis out the front of the MultiArray to the end of the slide travel.

5 If any disk drives are installed in the 8-bay disk drive chassis, remove the ribbon (data)

and power cables from the disk drives.

6 Remove the two rear chassis mounting screws and slide the chassis out the front of the

MultiArray.