Owner`s manual
Update–Firmware v. 4.101 3
8. The Start Copying Files dialog box appears. Click
Back to review or change settings. To begin copying
files, click Next.
9. As the files copy, the Setup Needs The Next Disk
dialog box appears and, in sequence, requests Disk 2,
Disk 3, and Disk 4 (key disk). Insert each requested
disk and click OK. The driver installs with each disk.
10. The Configuration Utility window and the Com
Port Change dialog box appear. Make appropriate
changes in the Com Port Change dialog box, if
necessary, and then click OK.
11. The Microsoft ISDN Accelerator Pack 1.1 dialog
box appears and asks if you want to install the
accelerator pack. (This dialog box does not appear in
Windows 98, which includes the Accelerator Pack.)
If it is not already installed on your computer, click
Yes and follow dialog box instructions; otherwise,
click No and close the Configuration Utility
window.
12. The Setup Complete dialog box appears. Make
sure Yes, I want to restart my computer now is
selected, then remove the Configuration Utility disk
and click Finish. The computer reboots.
13. As the computer is rebooting, insert the
MultiMobile into the computers PC Card slot with
the 68-pin connector facing the PC card slot and the
label facing up.
14. Plug the 15-pin connector into the 15-pin socket of
the PC card. On the other end of the 15-pin cable,
leave the RJ-45 receptacle exposed until ISDN
connection is made. Hardware installation now is
VCOMM & CAPI Installation (Win95/98)