Owner`s manual

Update–Firmware v. 4.101 5
Manual PC Card Installation (NT)
Multi-Tech’s configuration setting.
Note: If you enter Multi-Tech’s Configura-
tion utility to change the switch type and
phone number, the new settings overwrite
the ISDN configuration utility.
6. To complete setup, reboot your computer.
Windows NT Installation
Since Windows NT 4.x does not feature Plug and Play,
users must install the PC Card manually.
Note: Windows NT4.x only works with CAPI. The
ISDN AT command emulation also is available
through CAPI. Other API modes, such as NDIS
and VCOMM, will be supported by a later release.
1. Run Windows NT.
2. Plug the PC Card into your laptops PCMCIA slot.
3. Insert the Windows NT driver disk and click Start
è Settings è Control Panel; then double-click
PC Card (PCMCIA). Note the resources that NT
allocates for I/O range, IRQ, Memory, etc. You will
need this information when you check the Adapter
Settings in step 7 below. Then click Network.
4. The Network dialog box appears. Open the
Adapters tab and click Add.
5. In the next dialog box, click Have Disk. Enter the
driver path and click OK.
6. The Select OEM Option dialog box appears with
the device name (e.g. 56K Modem + ISDN Adapter
for CAPI) in the text box. Click OK.
7. The Setup dialog box appears. Make sure the
settings for the Adapter Setting and the Line