Owner`s manual

6 Update–Firmware v. 4.101
Setting below match the settings you noted in step
3 above .
Adapter Setting
I/O Base: Not used by any other devices
Interrupt: IRQ does not conflict with any
other device
Mem: Setting is for PCMCIA attribute
memory use. (Select one of the settings.)
Pcmcia: Select CARDBUS if the PC Card is
seated in the CardBus slot. Select 365
COMP for the non-CardBus PCMCIA slot.
If necessary, check the laptop user manual
for information on your PCMCIA slots.
Line Setting
Switch type: Select the ISDN switch type or
D-channel protocol
Modem I/O: Specify the I/O for analog
applications
Modem choice: Select the analog applications
Analog encoder: Select the encoding scheme
for your analog applications, modem over
ISDN, modem over PSTN, or ISDN Phone
(voice). This setting should be consistent
with the ISDN Voice Encoding in ISDN
folder in RVS COMMCenter (refer to RVS-
COM Lite for details)
Phone number: Enter the ISDN phone
number(s)
SPID number: For North American use
only
8. When finished, click Close.
Manual PC Card Installation (NT)