User`s guide

Page 100
9.5.2 Name and configuration selection
This screen is displayed after pressing Enter in the General screen if this
system was selected for message transmission.
GSM2503 Network operators 12-02-01 12.00.00
Ver 6.13 USERID SYSNAME
Type values and press Enter
Network ID . . . . . . . . . . 240-01
Network name . . . . . . . . . Telia Mobitel GSM Text
Cfg name outgoing/combined msg *SYS__ F4=List
Config name incoming messages *NONE_ F4=List
Configuration name alarm calls *SYS__ F4=List
Country prefix . . . . . . . . 46_
Service center address . . . . [phone]________
F12=Cancel
Name and Configuration selection
Cfg name outgoing/combined msg
Specify the configuration name to use for message transmission. If “*SYS” is
specified the value in General configuration, part 1, will be used.
Press F4 for a list of configuration descriptions.
Cfg name incoming messages
Not in use, leave the value “*NONE”.
Configuration name alarm calls
Specify the configuration name to use for placing alarm calls. It must be a
configuration of connection type 1 (asynchronous modem) or connection
type 2 (synchronous modem). If “*SYS” is specified the value in General
configuration, part 1, will be used.
Country prefix
Country prefix identifying the country when sending messages. The value is
the same as for international phone calls.
Service centre address
Service centre address provided by the GSM operator.