User`s guide

Page 67
Cfg name outgoing/combined msg
Specify the configuration name to use for message transmission. This value
is used only if “Sending system” is set to “*LOCAL”, and the corresponding
field in the network file is set to “*SYS”.
Cfg name incoming messages
Not in use, leave the value “*NONE”.
Configuration name alarm calls
Specify the configuration name to use for placing alarm calls. It must be a
configuration of connection type 1 (asynchronous modem) or connection
type 2 (synchronous modem). This value is used only if “Sending system” is
set to “*LOCAL”, and the corresponding field in the network file is set to
“*SYS”.
Port number for outbound comm
The port number used for outbound TCP/IP communication with the MidJet
NT Monitor program product.
Port number for inbound comm
The port number used for inbound TCP/IP communication with the MidJet
NT Monitor program product.
Enable reply function
This field controls if the message reply function is to be enabled. When
active, a reply number is added to messages with reply request. This is
performed when the message is sent, and the reply will be processed when
it arrives.
Specify 0 if the function shall be inactive, 1 if it shall be active.
Originator number
The originator number is sent together with the message, and shown on the
telephone display. This function is supported by some GSM operators and is
only in effect when messages are sent via a modem.