Owner`s manual

MT2834ZPX Owner's Manual

Configuration/Installation Procedure

Perform the procedures in Table 2-1 to configure and install the

MT2834ZPX card into your ISA or EISA bus host computer.

Table 2-1. Configuration and Installation Procedure

Step Procedure

1 Make sure your computer and any peripheral equipment

connected to it, are turned off. Failure to do so may damage both

your modem and your PC. The card may be installed in any 286-,

386- , 486- or Pentium based computer with an ISA or EISA bus

architecture.

2 Remove the cover of your computer as instructed in your

computer’s documentation.

3 Locate the unused slot(s) which you will be using for your modem

card, and remove the slot cover(s) per the instructions in your

computer’s documentation.

4 Figure 2-1 illustrates the default COM port and IRQ value setting

for this card (COM2/IRQ3). If your application requires an

alternate setting, remove the berg jumpers from the COM2/IRQ3

position and place them in a position that supports your

application. The MT2834ZPX can be configured for either a

COM1, COM2, COM3 or COM4 communication port; with a

selection of five IRQ values for each port. By this means, the user

may select an identical COM port because of the expanded IRQ

value selection option (e.g., the MT2834ZPX has a factory default

of COM2/IRQ3...a Mouse device can also be configured at COM2

but at IRQ4...a Printer device configured at COM2 but at IRQ7...).