Owner`s manual
34
MT2834ZPX Owner's Manual
COMMAND: &Sn
VALUES: n = 0, 1 or 2
DEFAULT: &S1
DESCRIPTION
:
&S0 forces Data Set Ready On.
&S1 lets Data Set Ready act normally.
&S2 Data Set Ready drop is regulated by
S24 on disconnect.
COMMAND: T
VALUES: n/a
DEFAULT: Tone Dial
DESCRIPTION
:
Modem will tone-dial numbers following the T.
COMMAND: &Tn
VALUES: n = 4 or 5
DEFAULT: &T5
DESCRIPTION
:
&T4 selects Enable Response to Request for
Remote Digital Loopback.
&T5 selects Disable Response to Request for
Remote Digital Loopback.
COMMAND: $Tn
VALUES: n = 1 or 2
DEFAULT: $T1
DESCRIPTION
:
$T0 selects calling tones on (1300 Hertz data/modem
mode only).
$T1 selects calling tones off (1300 Hertz data/modem
mode only).
COMMAND: #Tn
VALUES: n = 0 or 1
DEFAULT: #T1
DESCRIPTION
:
#T0 turns off Trellis Coded Modulation
#T1 turns on Trellis Coded Modulation