Owner`s manual

23
3 - AT Commands, S-Registers and Result Codes
Command Options Function & Description
\G0 * Disable port flow control
\G1 Set port flow control to XON/XOFF
\Jn Constant DTE speed option
\J0 * DCE and DTE rates are independent
\J1 DTE rate adjusts to DCE connection
rate after on-line
\K=n Set break control
In on-line data state with V.42 protocol
or normal mode, then break signal to
DTE through RS-232
n=0 or 2 or 4
Enter on-line command state but do
not send break to the remote modem
n=1
Empty the data buffers and send break
to the remote modem immediately
n=3
Send break to the remote modem
immediately
n=5
Send break to the remote modem in
sequence with data in on-line data
state with direct mode, then receive
break signal at serial port
n=0 or 2 or 4
Immediately send break and enter on-
line command state
n=1 or 3 or 5
Immediately send break through
In on-line command state with V.42
protocol or normal mode, and the DTE
issues a transmit break command
* Factory default setting