Owner`s manual

31
3 - AT Commands, S-Registers and Result Codes
Result Codes
In Command mode, the MT3410ZLX can send
information and status responses, or Result Codes,
to your computer. Result Codes are used by
communications programs and can also appear on
your monitor. The form of the Result Code
information displayed can be defined using the Qn ,
Vn , Wn and Xn commands.
Terse VerboseDescription
0OK Command executed
1 CONNECT Modem connected
to line
2 RING Ring signal detected
3 NO CARRIER Carrier signal lost or
not detected
4 ERROR Invalid command
5* CONNECT 1200 Connected at 1200 bps
6 NO DIALTONE No dial tone detected
7 BUSY Busy signal detected
8 NO ANSWER No answer at remotely
10* CONNECT 2400 Connected at 2400 bps
11* CONNECT 4800 Connected at 4800 bps
12* CONNECT 9600 Connected at 9600 bps
13* CONNECT 14400 Connected at 14400
bps
14* CONNECT 19200 Connected at 19200
bps
24* CONNECT 7200 Connected at 7200 bps
25* CONNECT 12000 Connected at 12000
bps
40* CONNECT 300 Connected at 300 bps
55* CONNECT 21600 Connected at 21600
bps
56* CONNECT 24000 Connected at 24000
bps
57* CONNECT 26400 Connected at 26400
bps